## Drop IP/ASI output on input loss

MK.IO Beam can be configured to drop IP/ASI output on input loss. This can be configured for **Live Encoder + Multiplexer** feed templates.

To configure this, follow these steps:

1. For the Live Encoder:

1. Go to the feed card then edit the Live Encoder by clicking `Edit` next to the **LIVE ENCODER** component within the feed.

2. Click the **Output** tab then click `Edit` to edit the output.

3. In the **Common MPEG-2 TS Parameters** section, set the **Signal loss management** to **Drop transport stream**.

2. For the corresponding Multiplexer:

1. Go to the feed card then edit the Multiplexer by clicking `Edit` next to the **MULTIPLEXER** component within the feed.

2. From the **Stream Processing** tab, click **Output stream > Service (x)**.

3. Go to the **Properties** > **Sources** sub-tab then tick the **Output Drop On Input TS Loss** checkbox.