lineup.md

Live service lineup encoding parameters

For each source, you can edit the following parameters depending on the source input type, either MPEG-2 TS/UDP or SMPTE ST 2110.

Parameter	Description
Stream address	Input stream unicast or multicast IPv4 address
Port	Port used to capture the input stream
IGMPv3 source filtering	IGMP source IP address. List of addresses allowed in IGMPv3 using a comma to separate.
Input synchronization mode	Input can be synchronized based on PMT program ID or on VCT major and minor channel numbers or the stream PIDs. Make a selection based on the information present on the input stream.
FEC port	Port used for FEC Possible values: From 1 to 65535
Streams	For each source select which streams will be used and enter the PIDs: List of stream identifiers using a comma to separate. Note: If no PID is specified, default PID will be used.

Parameter	Description
Stream Index	Index of stream within the SDP file. 1 is the first stream. Possible values: From 1 to 1000
SDP File Location	Location of SDP file describing the input stream. Either a URL or a file location. Note: The SDP File Location must be specified when Live Encoder service is configured with MediaComposer input type and an SMPTE ST 2110 source, but if you are using NMOS, you don't need to specify it, otherwise it will be ignored since the NMOS Controller supplies the SDP file.
Audio format	Select if the audio format should be automatically detected or forced. For uncompressed/Dolby E Passthrough select either 'AES Uncompressed audio' or 'Dolby E' as the input format, and 'SMPTE302/Dolby E Passthrough' from the encoding menu. Dolby E input will not work with Dolby AC4. To decode/reencode Dolby E select Auto or SMPTE337 compressed input as the input format.
Channel Group Index	Index of channel group within the SDP audio stream. 1 is the first channel group. Possible values: From 1 to 65535
DPI PID index	Specifies the index to the DPI PID which will carry the resulting splice_info_sections. Possible values: From 0 to 65535