## Configuring Bandwidth Policing Group

1. Create a new Multiplexing Service and configure the service settings.

2. Configure **Transport Stream** parameters.
   
   1. Open the **Mux** tab to configure total bitrate.
   
   2. Open and configure the **Output** tab:
      - Set an **Output Name**.
      - Set the output **Type** to IP.
      - Select the **network interface** and define the **stream address**.
   
   3. Open the **Bandwidth Policing** tab and configure the groups:
      - Click the **Add Group** button to configure a first group defined with a name and a bitrate.
      - Click the **Add Group** button to configure as many groups as needed defined with specific name and bitrate.

3. Assign the **Bandwidth Policing Group** to an output service to the transport stream.
   
   1. Click **add** to create a new output service.
      
      
   
   2. Set the **Service Passthrough** mode to **On** to display specific parameters.
   
   3. Select one of the **Bandwidth Policing Group** previously created.
   
   4. Configure the **Sources**' **Input** parameters with the appropriate **Network Interface**, **Destination IP Address** and **Port** number.

4. Assign the **Bandwidth Policing Group** to a video component of an output service.
   
   1. Click **add** to create a new component to an existing output service.
      
      
   
   2. Configure the **Input** tab parameters.
   
   3. Open and configure the **Output** tab and select one of the **Bandwidth Policing Group** previously created.
   
   4. Create and configure any other video component needed with specific **Bandwidth Policing Group**.

5. Click **Save and continue** to save your modifications.

6. Assign a server and start the service.

The service is running and **Bandwidth Policing Group** information (bpgId) are assigned to the service configuration files at both services and component level.

You can also monitor the [**Bandwidth Policing Group** statistics](/beam/multiplexer/monitor#bandwidth-policing) by clicking the `Pie chart` button on the Services page.