Configure the output | MediaKind Docs

Configure the output

MK.IO Beam can output decoded video, audio and data using one or more of the following transport methods for distribution to other devices:

SDI Output

Broadcast standard for transmitting uncompressed video, audio, and data over coaxial or fiber cables.

SMPTE ST 2022-6 Output

IP-based standard that encapsulates a complete SDI signal (video, audio, and data) into a single stream.

SMPTE ST 2110 Output

Native IP standard that transports video, audio, and data as separate, independent streams.

Transport Stream Passthrough

Convert a satellite feed into an IP UDP multicast transport stream and decrypt the content.

Output Profile selection

Some output configurations require optimizations to get the best performance. The following output profiles are available:

Output Profile Receiver Service Type Other Service Types
Standard Recommended for:
- SDI output (all video formats)
- SMPTE ST 2022-6 output (all video formats)
- SMPTE ST 2110 output (SD/HD video formats)		 Recommended
SMPTE ST 2110 UHD Output Mandatory for:
- SMPTE ST 2110 output (UHD video formats)		 Not recommended

These output profiles are optimized for the Receiver service and support mixed output configurations. For other service types, such as Live Encoding, use the Standard output profile.

Service Running Blocked by the Current Output Profile

In some cases, a Receiver service may be prevented from starting and entering the Running state. In this case, an alarm is raised indicating that the service configuration is not compatible with the selected output profile. Refer to the alarm description for guidance on resolving the issue and bringing the service into the Running state.

For example, if the output profile is set to Standard and a UHD receiver service is configured for SMPTE ST 2110 output, a Service blocked alarm will indicate that SMPTE ST 2110 UHD Output is required. While the alarm is active, the service remains in a Failed state and cannot enter the Running state.

Configure the Output Profile

To configure the output profile, follow these steps:

  1. Select Appliance from the left-hand side menu.
  2. Click the Output Profile tab.
  3. Select the appropriate output profile setting from the Output profile drop-down menu.
  4. Click the Apply and Reboot button.
  5. A confirmation pop-up window will appear asking, “Are you sure?”
  6. Review any warnings or guidance provided. If you are sure, click Yes, configure and REBOOT! Otherwise, click Cancel to abort.
  7. Following the reboot, refresh the web page. The reboot may take a few minutes to complete.